Welcome to Geeklog, Anonymous Sunday, February 25 2024 @ 04:52 am EST

Geeklog Forums

Default language During Setup


Would it be possible to set the default language during the installation of geeklog ?

I have migrated my site several times and I have found that I have to remove several strange symbols from the text in the articles and I have fond that it is a problem with the sites language settings that default to the top of the language list "Afrikaans" during the install.

I have over 8000 Articles on my site and its a bit of a pain to do it all again.


Status: offline


Site Admin
Registered: 01/12/02
Posts: 13073
Location:Stuttgart, Germany
Migration should leave the language settings alone. Unless you're upgrading from an old Geeklog version (1.4.1 or older) at the same time - in that case, you have to make sure that your old config.php is still there during the migration so that Geeklog can pick up your old language and character set settings.

bye, Dirk

All times are EST. The time is now 04:52 am.

  • Normal Topic
  • Sticky Topic
  • Locked Topic
  • New Post
  • Sticky Topic W/ New Post
  • Locked Topic W/ New Post
  •  View Anonymous Posts
  •  Able to post
  •  Filtered HTML Allowed
  •  Censored Content