Welcome to Geeklog, Anonymous Monday, February 17 2025 @ 07:38 pm EST
Geeklog Forums
1.4.1 -> 1.5.0 Config not read
Page navigation
Status: offline
Dirk
Site Admin
Admin
Registered: 01/12/02
Posts: 13073
Location:Stuttgart, Germany
Quote by: Jerry Green
I found that in the database gl_commentcodes` VALUES (0,'Comments Enabled',(1,'Read-Only'
,(-1,'Comments Disabled'
; existed. If I deleted the value 1, 'Read Only' then the update worked fine. I assume this was left over from an old version of Geeklog and had never been deleted.
Interesting. Yes, such an entry existed in ancient Geeklog versions. It should have been deleted by the upgrade from 1.3.5 to 1.3.6, though.
bye, Dirk
32
40
Quote
Guest
Anonymous
Quote by: Dirk
So those are the ones you enter in the install script during the upgrade? In that case, everything is working as expected ...
?
Again, everything that is supposed to be entered in the GUI is gone. Instead, it uses default values (e.g. "My Geeklog Site"

34
35
Quote
Page navigation
All times are EST. The time is now 07:38 pm.
- Normal Topic
- Sticky Topic
- Locked Topic
- New Post
- Sticky Topic W/ New Post
- Locked Topic W/ New Post
- View Anonymous Posts
- Able to post
- Filtered HTML Allowed
- Censored Content