Welcome to Geeklog, Anonymous Monday, December 09 2024 @ 08:11 am EST
Geeklog Forums
chinese in articles
Status: offline
raffles
Forum User
Newbie
Registered: 06/03/03
Posts: 11
Hi!
I found out that if people put chinese in articles it only works properly if Post Mode is set to "HTML formatted" but then people will have to care for their own linebreaks. (Otherwise I get just html-no for the characters) Is that correct - can I change that behaviour somehow?
You can check the behaviour by just copying the chinese at the end of this article which might anyway only be shown correctly if you have the right fonts etc. installed (the characters should be big5 however gb2312 will probably show the same symptoms - the used characters belong to both typesets anyway).
regards
Daniel - 大牛 - www.daniu.de
You can check the behaviour by just copying the chinese at the end of this article which might anyway only be shown correctly if you have the right fonts etc. installed (the characters should be big5 however gb2312 will probably show the same symptoms - the used characters belong to both typesets anyway).
regards
Daniel - 大牛 - www.daniu.de
14
11
Quote
All times are EST. The time is now 08:11 am.
- Normal Topic
- Sticky Topic
- Locked Topic
- New Post
- Sticky Topic W/ New Post
- Locked Topic W/ New Post
- View Anonymous Posts
- Able to post
- Filtered HTML Allowed
- Censored Content