Posted on: 12/26/02 08:43am
By: etegration
I have just migrate a site over to another but i did a fresh installation of GL 1.3.7, exported the user table and re-imported it into the new site's mySQL database. All is fine but when i use mass mail, it shows:
"Successfully sent 2 messages and unsuccessfully sent 0 messages. If you need them, the details of each message attempts is below. Otherwise you can Send another message or you can go back to the administration page.
Failures
No failures
Successes
Geeklog SuperUser
Moderator"
Why only 2? I have 13 users all together. Was there anything i did wrong in importing? am i not suppose to do it? i can still log in as moderator and admin using the password and userID is change to on my old site and now using that same userID and password, i can log into the new site.
Mass mail problem
Posted on: 12/28/02 05:11am
By: Dirk
Which user group did you select when sending the mail? As the note on the top of the mail utility form says, you need to select "Logged-in users" to send mail to all your users.
bye, Dirk
Mass mail problem
Posted on: 12/28/02 10:36am
By: etegration
hi dirk, yes i did select Logged-in users before sendnign out the mail and it returned that. Why? Anyhting i did wrong in importing?---http://www.etegration.com
http://itcow.etegration.com
Mass mail problem
Posted on: 01/03/03 07:26am
By: Anonymous (Anonymous)
no one?